For compressed air systems

The Mitchell Instrument  Energy monitoring value kit makes it possible for any facility to lower their energy cost and reduce their CO2 emissions by monitoring and optimizing the energy used by their compressed air systems.

FEATURES

• Cost savings Can facilitate significant energy and cost reductions without major capital expense


• Dualistic approach Measure energy data and condition monitoring data at the same time


• Basic kit Measurements are easy to set up and perform All basic instruments to measure energy efficiency of compressed air systems are featured in one convenient carrying case.

SKF Machine Condition Advisor CMAS 100-SL

The SKF Machine Condition Advisor (MCA) simultaneously measures machine vibration signals and temperature to indicate machine health and bearing condition.

The SKF Machine Condition Advisor provides an overall “Velocity” vibration reading that measures vibration signals from the machine and automatically compares them to pre-programmed International Organization for Standardization (ISO) guidelines. An “Alert” or “Danger” alarm displays when measurements exceed those guidelines. Simultaneously an “Enveloped Acceleration” measurement is taken and compared to established bearing vibration guidelines to verify conformity or indicate potential bearing damage.

The SKF Machine Condition Advisor also measures temperature using an infrared sensor to indicate uncharacteristic heat.

SKF External sensor kit for the SKF Machine Condition Advisor CMAC 105

The external vibration sensor with magnet provides convenience for hard-to-reach surfaces and more repeatable and accurate measurements.

UltraSonic Leak Detector: Ultraprobe 100 Kit UP100KT

• Contact ultrasonic listening allows detection of faulty equipment




• Optional remote transmitter ("warble" tone generator) can be used for tank leak testing (instead of pressure test); transmits ultrasound through leaks, which is detected and displayed by the meter




• Inspect rotating machinery for early detection of possible gear and bearing failures




• Ultrasonic frequency range 20kHz and 100kHz; plus




• Eliminates extraneous plant noise with noice cancelling headset.

Non Contact IR Thermometer with Laser

• Measure Infrared Temperature from -4°F to 999°F




• Simple operation, pull trigger and read temperature




• 12:1 distance to spot ratio




• Large dual display with backlight




• Laser target system helps to pinpoint targets




• Measure min & max, and average temps




• Pistol style IR Thermometer design for simplicity




• Auto Power off fuction saves battery life

Hioki 3197 Power Quality Analyzer Kit - 500/5000 Amp Flex

The Hioki 3197 Power Quality Analyzer is an Electrical Contractor Style Unit that is Easy to Use and Quick to Setup, this kit includes three 500 or 5000 Amp Dual Range Flexible Current Probes

• QuickSet function sets power quality detection levels to industry standards


• Simultaneously Detect Transient Over-voltages, Voltage Swells,Voltage Dips, Interruptions, Inrush Current


• Capture Power Conditions at a Glance;Voltage,Current,Active / Reactive / Apparent Power, Power Factor, Displacement Power Factor, Active/Reactive Energy, Demand, Harmonics (voltage, current, power),THD, Unbalance,K Factor, Phase Angle 


• Control and Download Data to your PC via a USB connection


• Frequently Measured Power Quality Conditions are Preset for Easy Access


• Up to 6 Hours of Continuous Use with the Rechargeble Battery